240sx

hello, selling my forged ca18det with about 8k km, everything works just fine, compression is checked. selling as a full swap(gearbox, engine, ecu, harness, mounts, manifolds..etc). there is a lot to tell but the main mods are: ARP in all engine CP pistons K1 connecting rods acl sleeves 444cc...

Hello! After a project S13, I Haven't really got a budget as long as it fair deal! Let me know if anyone has one for sale! Thanks!

Hi Looking at re-proding the rear arches for my S13 hatch, does anyone have the measurements (angles etc) of the stock rear arch opening? cheers

Manifold gets hot fast, car buggs when i try to rev it. Sparkplug 1,2 and 3 is good. Sparkplug cyl 4 is wet of fuel. Timing is good, no leaks and fuel pressure is good. Tps also good. No faultcodes on the standalone. When I turn of leancut on the ecu it acts alot better. Have gone over...

Having issues on my sr20det. Idles good, but as soon as i touch the gas it falls on its face. Also backfires in the intake. So im guessing timing, but when cylinder 1 is at tdc of compression stroke, cam lopes points out, marks is at 10 and 12 and vas is set correctly. Can say that I did rotate...

Hey. Replaced my headgasket and on startup the car is running lean and struggles to get the rpms up due to missfire. Have pressure tested the hole engine and fixed all the leaks. But, if i rotate the cas away from 15° btdc i runs alot better. So is it possible that i have installed the cas...

Hello again, so i would need help or directions where to look for or for what in this project car. Basically its friends old project car, like old old, it was meant to be build back then but it didnt happen and now its mess. Its 240sx coupe body originally with A/T now stripped and KA is out...

Have now taken the head off and can clearly see that cylinder 4 is full of coolant. But, headgasket doesnt have any crack and the block and head too is crackless. So now im wondering what it could be. Will check both head and block for warpage. So if anyone have any pointers to what i can check...

Hey. Have a s14 with sr20 and everything was fine untill i drove it around the block once, didnt go over 2500rpm. But once i got back at had tiny backfires at idle and got the fault code egt ch3 to high, what could be wrong?

Sadly I have to let go of my 1991 Nissan 240sx coupe with a 1 JZ VVTi swap. This can either be a badass street or a ready to rock drift car. The interior is complete, there are no parts missing. The car has no rust underneath, it’s generally a really rust free example. Front-, back-...

Hello, looking for glare 180sx/240sx sideskirts from car modify wonder

In search of a Nissan 240sx, any condition. Preferably a 89-94 s13 coupe Modified or unmodified. I am looking for something within Canada, is there anything out there? Feel free to send anything you got to dgreashore@gmail.com Thanks for looking.

Hey. My Sr20det s14 dies while driving. All started when I replaced injectors. Replaced injectors, got the car running, but idle was bad. Then replaced TPS and intake gaskets and idle got better. Then went to drive it and the car died while driving at low speed. Installed a new FPR with gauge...

Hey. Ive got an S14 with an sr20det thats recently hydrolocked due to bad injector. I have replaced the injector but the car wont run right. It idlea bad once hot and when I go to drive it it turn itself of if i give it too much gas. Ive checked: IACV TPS ECU coolant temp Compression Ignition...

Hey. My sr20det got hydrolocked due to stuck injector, changed the injectors and the car started fine. But after the car gets hot now, the idle drops to 400-500rpm and it idles really bad. Sometimes even stalls. I have gotten a fault code of a bad tps and replaced it. Now the rpm dont change...

Hey guys, I just got my permit and want to start on a car before I can legally drive. I'm looking for any year 240sx but I cant find any under 3500, which is basically my limit. All I see is how cheap these cars are, but I don't really see that. I'm looking in California, Nevada, Arizona, Utah...

Hello! I'm looking for the front shoulder belt for a 240sx s13 (the automatic belts). I live in sweden so need it shipped here. Anyone have that for sale?

NO TIMEWASTERS, PLEASE READ THE DESCRIPTION. Any stupid offers will just be ignore, without trying to sound like a w*nker i'm bored of people offering me £800 Nissan 200sx s13 V5 Present in my name. Between the car and spare parts you could make a small fortune if you were to break it, I...

anyone got an s13/s14 or ps13 carpet they don’t need? Text me: 07506412010

Need square style front and side indicators for Nissan S13!