misfire

  1. J

    Ca18det Misfire issue

    Hello, so I’ve been having this issue with my ca18det where it will start to hesitate and misfire trying to rev over 4K. I’ve sorta narrowed it down to tps I have tested it and everything seems okay. I’ve heard it needs to be set to 0.5v closed but the issue I’m having is I can only adjust it to...
  2. japcannon420

    S15 unknown electrical fault

    Hi all, My Silvia has recently developed a strange problem. It misfires and runs on 2/3 cylinders all the time its running, except when the key is turned to the off position or removed, it will then run normally for about 3 or 4 seconds before dying. I have checked that im getting spark on...
  3. K

    1jz vvti 240sx hesitation partial throttle (when warm only)

    I have a 1jzvvti from a jzz30/jzx100, stock auto ecu, stock injectors, big holset single, all bolt ons, new bkr7s plugs, maf cleaned, stock coilpacks, tomei fpr, new walbro, safc installed to monitor rpm/knock. When the engine is just fired up and I go through the power band everything works...
  4. D

    1jz vvti misfires and looses power, but runs better with coolant sensor unplugged

    I have a s14 nissan with a stock auto 1jz vvti engine in. For months now I can't find the problem. The car when it reaches running temp and you start making boost suddenly feels like a switch is flipped, turbo screams to make boost but nothing, no power amd misfires, can only accelerate without...
  5. E

    25de+t misfiring at 4k rpm

    I recently bought a 25de+t 32 drives nice, but at 4k rpm with your foot down starts missing like crazy, if I go easy on throttle easy gets to 7k. Running 550cc injectors on 20psi fuel pressure. Changed spark plugs, because the guy I bought it off put $8 plugs in, swapped for iridium's and...
  6. C

    1jz vvti Misfire cutout getting into load, bad vvti solenoid?

    1jz vvti Ecumaster emu standalone Bosch ev14 1000s Pte 6466 Bosch lsu 4.2 wideband in place of factory o2 Stock long block. Fuel pressure 43psi Before this issue i drove the car into the car running perfect when it was bone stock engine (turbo, injectors) on emu. I pulled the cams and head...
  7. M

    CA18DET Misfire After Hard Pull....?

    Hi all, Recently picked up a CA S13. Had a T28, Walbro 255, 3" exhaust and intake etc. Have fitted a Horsham Stage 2 chip. Boost is set to around 12psi at the moment (adjusting wastegate/boost controller at the moment) Twice now, after a hard pull in 2nd gear, it's developed a constant...
  8. holdawayt

    Newbie with a troublesome S14a

    Morning guys, I've lurked on the forums for some time now researching the S bodies more than anything else. I bought a bit of a dog if I'm honest. I was aware that it was rusty and had a boosting issue but it's one of those cars where the more you dig, the more you find. I'll start up a prog...
  9. fella

    Rb25 misfire – not the usual suspects

    Right then folks, I have been a long time member on here, but as you can tell by my post count, I do a lot more reading and learning than contributing! However as the title suggests I have a problem with the RB25DET in my C35 laurel and it has got me utterly utterly baffled. Basically...
Back
Top