welding

Before you all say it, I know, I'm a damn idiot. I wasn't sure of the jacking point for an S13 and was rushing. I use a circular pressing on the passenger side.. the jack put a hole in the floor of my car (FML - see image). Do you think it is repairable? And where are the jacking points?

hi everyone i am a qualified mechanic offering a tig welding service based in ashford kent i can weld aluminium ,stainless steel and mild steel even aluminium wheels if your interested give me a message on 07701339455

Is Chromoly stronger than DOM? What are the pros and cons of these two metals? I’m asking this because i want to build my roll cage with strong tubes, so i gotta know what i’m using.

Hey lads and lasses, Two quick questions. Has anyone got any knowledge on the best place to buy spiked lug nuts, and which is the best or a good brand to look out for? And also, Has anyone ever paid anyone to take off rust and treat the whole under side of there car including removing...

Hi all, looking for a bare shell from a 350z, as I'm cutting the roof off and welding the roof section and tailgate to another car to turn a convertible into a permament coupe (well, I'm not, but Grant at GC Fabrications has agreed to), so I'm after a bare shell or for someone to cut the body...

E36 compact. Basically the drivers side front anti roll bar mount has rotten out and the bush and bracket have broken away from the chassis. What would be the best way to go about repairing this and can you get patch sections if so where from

Hi, Looking for someone to recommend a good reliable welder in Manchester area. My R32 needs some attention on the sills before it's MOT in April. They're rotted quite bad so want it doing well however cosmetically doesn't need to be that pretty as it'll have a kit fitted once it's done. No...

hi all i am planning to stitch/seam weld my unibody for increased stiffness. i know that the body must be carefully leveled but i was wondering the correct way to support the car on jack stands in order to ensure it is not welded into a twisted shape because of the stresses and distortion...

So, as stated my S13 (yea no surprise there that an s13 has rust?! :O ) has been sat for almost 2 years now while i've been off at uni and has collected some rust. A few of the obvious stuff, like arches and sills but the subframes aren't looking too great either. I'm worried that if i...