180sx Turbonoz install question

[marki]

I recently installed a chip from turbonoz in my 180sx sr20det ecu. I tried in an E5 and a 62 ecu but it doesn’t seem to be working. It’s as if the ecu isn’t reading the chip at all. I have triple checked my soldering on the manifold and the jumper CJ1 to CJ2. The red light on the ecu just stays on. It idles rough and over fuels. Am I supposed to do something else to make the ecu read the chip? Thanks.

 

[Cades]

Bin the generic chips off and get a proper ecu and map

 

[r3k1355]

Have you e-mailed Noz about the problems?

You can muller the chip if it's accidentally soldered in backwards can't you??

 

[marki]

Have you e-mailed Noz about the problems?

You can muller the chip if it's accidentally soldered in backwards can't you??

I have emailed and called several times but no replies or answers.

 

[r3k1355]

Have you tried on Facebook? People used to be able to get hold of him on that.

https://www.facebook.com/Turbonoz
https://www.facebook.com/NoelUhure

 

[marki]

Have you tried on Facebook? People used to be able to get hold of him on that.

https://www.facebook.com/Turbonoz
https://www.facebook.com/NoelUhure

I have tried the fb page but I’ll try his personal page now! Thanks for that. I have read only good things about noz so it’ll be nice to get it going the way it should!

 

[green200b]

It's a bit of a thread revival, but does anybody have any contact with Noel/Turbonoz? I have tried emailing, calling and contacting via Facebook but have had no response.