** BDC/Fabricage group buy 2011 **

BDC

BDC

BDC FTW!
Ladies and gents

Once again the BDC in association Fabricage bring you a group buy for roll cages that are built to or supplied to conform to BDC rules and regulations.

Cages are available for the following cars;

Nissan
S12 Silva
S13
S14
S15
R32 2 door
R33 2 door

Ford
Escort MK2

Toyota
Corolla AE86 Coupe

Cages can be made for ANY vehicle, for this you must leave your contact details as explained below.

Fabricage also offer a roll cage for the Nissan S14 which comes in a kit form for those wishing to fit/weld in their own cage.

If you do not wish to fit a full 6 point cage then rear half cages are available with front sections available separate at a later stage if required.

2011 prices will be, (bolt in)

£238.42 rear cage
£224.03 front cage
£40.11 door bars each

Full BDC specifications roll cage with single door bars £542.67

Full cage with ready made X door bars are available for the S14 £672.00.

Weld in cage. Available for Nissan S14 only.

This roll cage comes in kit form with X roof diagonals, X door bars/rear diagonals and other triangulation as shown in the car below. All tube ends are profiled for customer fitment £695.00

DSC_078111.jpg


DSC_0778.jpg


DSC_0783.jpg


For bolt in cages cages not supplied with X door bars, add on door bars can be purchased at £32.00 each including brackets, nuts and bolts

Additional X diagonals and various colours’ other than black are available at an additional cost.

All roll cages will be supplied in black unless an alternative is ordered.

Fabricage can also supply roll cage tubing at £9.50 per metre and brackets £9.50 per
set.

All prices are plus carriage + vat

To take up this offer which is open to anyone, we require you to send your full name and day time contact telephone number via a pm or email bdc@live.co.uk

Your details will be passed on to Fabricage who will then contact you for your requirements and enquiries.

Many thanks

The BDC team.
 
In answer to the question,the weld in s14 cage will not fit with the sunroof in if it is a retractable roof as the roof diagonals are too close to the roof,pop up roof would be ok .
 
i would take all the sunroof out and weld a piece of sheet metal over the hole so it would be ok then as the diagonals would have enough room? sorry for all the questions
 
no problem asking questions,it saves you getting something you don't want,yeah,plating roof will be fine,if you want to call me 01223 870563,i'll be happy to discuss any other queries.
 
all front cages are through dash,but for s13 we also do one that does not go through,not a dash dodger,it goes straight down to floor.
 
sorry,don't do a cage for this car,i would need to have the car here to design one,maybe we can take a jig from your car and do it cheaper,give me a call if you want to discuss it.
 
Sw20 said:
Do you do anything for the Mk2 Mr2? Looking for a 6pt MSA spec cage preferably bolt in too
Click to expand...
At the moment no i don't, but i have just been contacted by an existing customer about jigging for this car,you can contact him on 01536400300 ask for mark,if it's not the same model call me 01223 870563 and we can discuss options.
 
i bought an S14 bolt in cage apparently with everything it should come with for £714 delivered all in.

does this come with two door bars? any pics of one fitted?
 
You must log in or register to reply here.
Back
Top