beefy berlinetta

B

bigsquat340

New Member
any love for the old manta here / anyway here she is 1.8 berlinetta usual rust problems biggest being the A post up into the lower windscreen pillar but i will sort that with a section from a scrap shell ime still undecided wich way to go i was going to go classic thunder saloon lookswise but just crack on see how it ends up motor ime thinkinglexus v8 or bmw

100604351_10158824464862240_4499058296455430144_n.jpg
 
Last edited:
front floors swan necks both doors full nose cone both Aposts need doing i have most if not all the bits for thos areas as well as these i made

100052525_10158824464622240_6137292929208680448_n.jpg


100858335_10158824463822240_1813874541479329792_n (5).jpg
 
few more so folded upsome steel channel a bit thicker than stock also had itso a 60 x40 box section would sit in thereperfect but still look stock from outside [relatively]

126173241_203991694473587_6512238710701464493_n.jpg


126482316_137881844366715_5991704337290438984_n (2).jpg


a post8.jpg


box_LI.jpg
 
I love these things, my grandad had a black, a couple of white and a red one over the years, they were all GTE I think. He rolled the white one and ended up in a ditch upside down, he walked away unscathed, brilliant under appreciated cars.
 
yes it has potential now xmas is out the way get started on it hopefullyget some updates postedover the next week or two
 
If you haven't caught on to it yet, the 1.8 gearbox is pretty rare and valueable! It makes a C20XE or C20LET swap in the old Mantas/Asconas/Kadett an almost bolt on one. Paired with the engine mounts, prop, sump and pickup it is a bolt on swap in Manta and Ascona B's. A pretty popular swap so make sure to get what it's worth for those parts ;)

A V8 would be awesome in that car! The BMW unit is a pretty big lump, if you are choosing between Lexus and BMW I'd recommend the Lexus. If memory serves it's a bit narrower.

I chose an Audi engine for my Kadett for that reason, and becouse it's short. (in fact, Audi's V10 engines are about the same length as a small block ford engine) Hard to find smaller DOHC V8's than Audis! Makes for different challenges but.. Atleast I didn't need to cut up the engine bay :)
 
thanks mate box section in the sill is to tie into the pillar wich is a problem area on these and the inner pillar is not available as a replacement panel but theres an outer cover that is
 
You must log in or register to reply here.
Back
Top