BMW E36 Seat Mounts

R32 GTR

R32 GTR

Active Member
Hi,

can someone get back to me about my issue with the seat mounts that i purchased?

They sit too far apart for the seat to fit into, i have Automac mounts which are in essence the same thing but they fit fine:-

 
R32 GTR said:
can someone get back to me about my issue with the seat mounts that i purchased?
Click to expand...

How did you contact us previously?

You need to space the gap, they're a universal frame, they can't fit all seats to the mm.
 
Kam, it was via the contact us section on the site.

They are labelled very clearly on the site as BMW E36/E46 seats so hardly universal? My Automac ones are specific to an E36 and fit every seat i have put into them?
 
What is your email address?

They're universal in terms of seat fitment, not car.
That's what you're saying? When they're bolted to the car, the seat is narrower than the frames?
 
I must say, I have these for my passenger side with an older version Sparco Pro2000 and fit without any problem (y)
 
We don't have any contact from you.

When they're bolted to the car, the seat is narrower than the frames?
 
What seat is it? I was under the impression that all 'standard' width side mounted bucket seats were the same width (approximately 400mm)
 
R32 GTR said:
Kam, i sent it through this link Contact Driftworks

Yes thats correct when the frames are bolted to the car the seat is narrower than the frame
Click to expand...

I know, you said. We don't have any contact from you - I'm looking into that, but we get loads.
As above, you'll need to space the seat. Not all seats are the same. Send it back if you don't want to :)

James998 said:
What seat is it? I was under the impression that all 'standard' width side mounted bucket seats were the same width (approximately 400mm)
Click to expand...

Wrong.
 
You must log in or register to reply here.
Back
Top