custom bonnet vents...

H

hybrid

Active Member
i have a few sets of bonnet vents,similar style to the scoot rx7 vents..these are very large...i looked for ages and asked everyone for a japenese style/looking with big slatted vents...could not get any so made some...will take a pic in morning and post up...looking for 140.00 per pair...cheers :smash:
 
i had them made and they can be used on virtually anything...they are very large i am going to use a pair on my skyline...
 
P1010043a.jpg
 

Attachments

  • P1010043a.jpg
    P1010043a.jpg
    75.4 KB · Views: 0
right rough dimensions are at the widest end it is 29.5cm across and the opposite end is 21.5 cm across,length is 76cm,measuring from top to bottom both sides....you will need to cut the vent openings,i have cut one so you can see how they look...cheers...
 
I want to strip my bonnet and fit some vents but for £140 i could find a cheap s/h already vented bonnet. As mitto said if they were like £70 or less i'd be interested, but not at £140 (unless they were Carbon Fiber, asthen they wouldn't need spraying).
 
blimey you lot...mitto i asked you about vents last year and the best you could do would have been roughly 300.oo from japan you said...these vents cost me 106.00 per pair,as i had to get 6 sets made at a minimum...so at 140.00 inc pxp i would have said it was a good deal...
 
whats your ebay thang......

ill defo take a pair for £100, and will more than likely get more sold for you

pm me your thoughts
 
You must log in or register to reply here.
Back
Top