Driftworks Hydro lines

[jflather_105]

Hi guys,

I bought the Driftworks hydro handbrake w/Wilwood cylinder and I got the braided input and output lines to go with them.

I’ve gone to fit it all in and I’m struggling to work out which way the lines plumb into the cylinder. The input line has both Banjo connections and the output line has the single. The larger banjo bolt seems to fit the input line but the rear connection on the cylinder if that makes sense? Also all the banjo’s seem to have different thread pitches as well.

Would someone be able to show me a picture of how they should be routed?

 

[DW-shop]

HI there

Sorry for the late reply on this I have been extremely busy and unable to get time to check the forum for a little while sorry.

The input line has a 7/16" to go to the handbrake and M10x1 to go too the M/C on the car.
The output line has 3/8" for the output on the handbrake and M10x1 for the rear T piece.

We have an image that may help in working out how to route your lines here.

Hopefully this helps with fitting this.

Apologies again for the delayed reply.
Alex