Gt3071r?

D

driftescort

Active Member
Can you get these with a T3 flange? I'm thinking of fitting one to my RB20 and it would be cool if I could get it to bolt on. I have seen cossies with these on and they are T3 flange so I suppose it is possible.

Also if it is possible what kind of downpipe flange am I looking at? Could you get a skyline fitment 1 or would I have to go for something like a V-band?
 
Afraid not, T25 flange only, there are different housings with flanges available but not direct from Garrett. Often it's a housing from a diesel application or similar so they won't approve or sell it for petrol use (higher temps).

Realistically it's not going to fit on the stock manifold anyway, so just modify your existing manifold with a T25 flange (I did this for an HKS 2835, which is basically a 3071) or build a new one. :) Output flange would be a 5 bolt a la SR downpipe, but you'd still really have to fabricate something, again this is what I did.
 
Cool. Was thinking I would have to go that way anyway.

What do you think would be the best exhaust housing? I was thinking .64 for response and its still a 2 litre but what about .86 as the RB revs that bit higher than a SR and for a bit more power
 
You must log in or register to reply here.
Back
Top