CrossOverPics
Member
Its time to sell my s13 which ive owned for about 5 years.
ENGINE:
SR20DET from an s14
Custom s13 to SR loom from norfy
T28 with HKS actuator
Tubed manifold
Front mount intercooler
Driftworks rad
HKS air filter
Just had the vvt sprocket replaced under 500 miles ago
Has an uprated clutch (unsure of brand)
Full 3 inch exhaust from turbo back
Walbro 255 fuel pump
Battery in the boot
Welded diff
SUSPENSION:
HSD coilovers
Aftermarket rear toe arms
Tein rods + ends for more lock
4 to 5 stud spacers
BODY:
GP Style front bumper
EPR tined indicators
Vertex side skirts
GP style rear bumper
+25mm front overfender
+30 rear overfenders
17x9 Rota Grid Drifts with brand new tyres all round
INTERIOR:
Sparco Rev bucket seat
Genuine Bride rail
Boost Gauge
Genuine OMP steering wheel
DW handbrake button
Scene af pull ring
BAD BITS
Bodywork is tatty
Needs paint
May need a new throttle body
Needs a stage 1 ecu.. is overfueling
Has had welding done to the floor a few years ago
Underside is a bit rusty
Needs new brakes
Using 4 to 5 stud spacers, was going to get a 5 stud setup eventually
Shell is on 168k
Clutch release bearing is noisy
Located Cheltenham
PM me, i work nights so may not reply straight away, but i'll get back to you asap.
07931199192
Looking for £4,500 ono.
May PX.
ENGINE:
SR20DET from an s14
Custom s13 to SR loom from norfy
T28 with HKS actuator
Tubed manifold
Front mount intercooler
Driftworks rad
HKS air filter
Just had the vvt sprocket replaced under 500 miles ago
Has an uprated clutch (unsure of brand)
Full 3 inch exhaust from turbo back
Walbro 255 fuel pump
Battery in the boot
Welded diff
SUSPENSION:
HSD coilovers
Aftermarket rear toe arms
Tein rods + ends for more lock
4 to 5 stud spacers
BODY:
GP Style front bumper
EPR tined indicators
Vertex side skirts
GP style rear bumper
+25mm front overfender
+30 rear overfenders
17x9 Rota Grid Drifts with brand new tyres all round
INTERIOR:
Sparco Rev bucket seat
Genuine Bride rail
Boost Gauge
Genuine OMP steering wheel
DW handbrake button
Scene af pull ring
BAD BITS
Bodywork is tatty
Needs paint
May need a new throttle body
Needs a stage 1 ecu.. is overfueling
Has had welding done to the floor a few years ago
Underside is a bit rusty
Needs new brakes
Using 4 to 5 stud spacers, was going to get a 5 stud setup eventually
Shell is on 168k
Clutch release bearing is noisy
Located Cheltenham
PM me, i work nights so may not reply straight away, but i'll get back to you asap.
07931199192
Looking for £4,500 ono.
May PX.
Last edited: