For Sale R33 Skyline and Misc clearout! (Bee*R, gauges, turbo timer, bumper etc)

M

Mikey637

Member
Hey guys, need to clear some space so these bits must go!

Prices are plus P&P or can be collected from RG45

Happy to hear offers, offer discounts for multi purchases, combined postage etc!

R33 GTST Front cut knuckles - £180 £150
One bearing free, one seized

R33 GTST / S14a extended LCAS - £120 £110
+25mm and braced for strength

Genuine Bee*R Rev limiter - £110 £100 £90
Bought off of a member on here and never got round to installing it
Beer.jpgBeer2.jpg

R33 GTST / S14(a) Lower control arms - £45ea / £80pair £40ea / £75pair £65pair
No hole drilled for ARB
lca1.jpg

R33 GTST +25mm wings - £130 £115 £100
Fibreglass GTR style non-vented, small chip on one corner but easy enough to build up
Wing1.jpg Wing2.jpg Wing4.jpg

Malpassi 1:1 Rising rate FPR - £55 £50 £35
FPR1.jpg

Coolant temp sensor - £15 £12 £8
Comes in 36mm housing
Water1.jpg

Polished R33 GTST coilpack cover - £25 £20 £15
Recently polished
Coilcover2.jpg

3 gauge dash pod - £15 £12 £8
Gauge1.jpg

Prosport gauges - £20ea £15ea £12ea
Coolant (sold) / Oil temp and oil pressure
Gauge3.jpg

Mocal sandwhich plate - £30 £25 £15
Has take off for cooler and comes with oil pressure sender
Mocal1.jpg Mocal2.jpg

Genuine Bosch lambda for R33 GTST - £35 £25 £20
Under 5000miles on it, replaced it as part of testing and since proven working via Nissan Consult. Part # 258003256
37929631_1937562659640269_6527959310457110528_n.jpg

GFB Dual port BOV - £80 £75 £65
Can be used to fully recirculate or vent or can do both (very useful for MAF based cars as it stops stalling and bogging on lift off)
GFB2.jpg GFB3.jpg

R33 GTST OEM "Type-M" Skirts - £OFFERS
OEM, will need a slap of paint as the original is flaking a bit


Thanks to anyone that has actually sat and scrolled through all of that! :D

Master1.jpg
 
Last edited:
GethinD said:
Do you know if the sandwich plate would fiit an RB20DET?

And is it thermostatic?

Thanks
Click to expand...

Should fit an RB20 absolutely fine as it's a 3/4 unf. Not thermostatic. My understanding is you remove the water/oil heat exchanger and this fits in it's place or you'd need a replacement 3/4 unf stud (<£5)
 
hey mate, I'm interested in the remaining gauges, are these stepper motor type gauges? 30mm depth and 52mm wide?
 
nas80 said:
hey mate, I'm interested in the remaining gauges, are these stepper motor type gauges? 30mm depth and 52mm wide?
Click to expand...

Sorry for the later reply! I'll grab some measurements in a moment and PM you. Not sure if they've stepper I'm afraid
 
You must log in or register to reply here.
Back
Top