keenbeard
New Member
Hey everyone, just gauging if their was any interest in this,
NOTE: This car is not running and is currently a project
I have a 1994 Mazda FD3S Rx7 that I’m willing to part with for a swap or for the right amount of £.
Car includes:
-freshly rebuilt motor built by old ones, (large street port)
-E&J racing apex seals, upgraded side seals, corner seals, and water jackets as well,
Cx racing coil overs,
Origin front and rear fenders,
Alex Rodriguez ABS delete,
Power flex bushings,
Fresh powder coated subframe,
99 spec twin turbos,
Unknown V mount radiator kit
Apexi power FC with hand controller,
ACT competition clutch & flywheel,
Unicorn angle kit,
Elite rotary OMP delete
Himni Racing motor mounts
Blitz NüR exhaust & downpipe
In the next few days will have:
Stoptech pads & rotors,
Powder coated comtrol arms,
Full origin labo kit,
Issues with the shell,
Minor rust on the rear quarter panel,
Paint is faded,
Overall it’s a great car, before I started the project handled and drove well on and off the track, motor was pulled because I want/wanted to make it stronger. If you have any questions I’ll be happy to answer them.
NOTE: This car is not running and is currently a project
I have a 1994 Mazda FD3S Rx7 that I’m willing to part with for a swap or for the right amount of £.
Car includes:
-freshly rebuilt motor built by old ones, (large street port)
-E&J racing apex seals, upgraded side seals, corner seals, and water jackets as well,
Cx racing coil overs,
Origin front and rear fenders,
Alex Rodriguez ABS delete,
Power flex bushings,
Fresh powder coated subframe,
99 spec twin turbos,
Unknown V mount radiator kit
Apexi power FC with hand controller,
ACT competition clutch & flywheel,
Unicorn angle kit,
Elite rotary OMP delete
Himni Racing motor mounts
Blitz NüR exhaust & downpipe
In the next few days will have:
Stoptech pads & rotors,
Powder coated comtrol arms,
Full origin labo kit,
Issues with the shell,
Minor rust on the rear quarter panel,
Paint is faded,
Overall it’s a great car, before I started the project handled and drove well on and off the track, motor was pulled because I want/wanted to make it stronger. If you have any questions I’ll be happy to answer them.
