200sx

5x114.3 17x9.5 ET15 Freshly refurbished and powdercoated in metallic silver. Probably seen 10 miles maximum on the road. 225/45/17 nearly new budget tires (also have another pair, same condition and brand I can sell with the wheels) No centre caps. I would like to swap these for a pair of...

Freshly painted in silver. Will post at buyers expense. £85

Parts clearout will take 400 for the lot S15 SR20DE head, powdercoated valvecover, oem gasket, skimmed, cams - no vct sprocket 200 firm SR20DE block mint condition 100 firm SR20DE cams 70 firm S15 5 speed driveshaft 70 firm s15 sr20de clutch pressure plate,flywheel 50 firm sr20de pistons rods 40...

Hi, I am looking to get a nice short ratio diff for my s13 200sx, currently i have the stock 3.916 ratio and i feel like its too long, i know the autos came with 4.3 and I would like to get one but they are very hard to find i feel like. I've also heard that people use the crown / pinion out of...

Looking for an S15 Spec R with 15k budget (can add a little for the right car) Message if anyone has one for sale Picture of my old one for attention :)

I have a few spares lying around in the Garage that I want to clear out due to an upcoming house move! All parts have come from a UK '94 Nissan 200sx S13. The list as follows is what I currently have, I do have boxes with some parts in which I can look through if you are requiring certain bits...

Hi ill be selling SR20 parts the parts will be ready for sale next week complete s15 spec s bottom end (it is apart) block, crank, pistons rods - great condition, complete oil sump upper, lower, pickup, windage tray, oil pump i also do have DET rods that can go with it, clutch and flywheel...

Hi Looking to source some rear quarter panel cuts from an r32 gts/gtr even a r33 or s13/14 as the rears are quite similar. Postage to AB41 or can collect if not to far away Thanks

Hey. My sr20det got hydrolocked due to stuck injector, changed the injectors and the car started fine. But after the car gets hot now, the idle drops to 400-500rpm and it idles really bad. Sometimes even stalls. I have gotten a fault code of a bad tps and replaced it. Now the rpm dont change...

D2 Racing-III Coilovers For Nissan S13. Bought for my project but no longer needed, never got round to fitting on my car. I had the Springs Powder Coated in White, cleaned up the shafts and gave them a general tidy up, got the ready to fit but another set came along that I bought to use...

Hi guys, im having a clearout of parts for s chassis, the parts are located in Slovakia, im willing to post majority of them, i do have an idea for prices but im willing to take offers. Recently broke down a SR20DE out of a s15 spec s, parts have 73k km the parts for sale from this are: Starter...

Fully rebuilt T25 (GT2552) turbo with upgraded drop-in 6/6 billet compressor wheel for improved spool & torque capability New inconel turbine shaft New billet compressor wheel Upgraded 360* thrust bearing & seal plate New seals, piston rings & journal bearings VSR balance Compressor &...

Having a bit of a clearout of parts I no longer need. S15 drivers side tail light. A small part of the rubber seal has come off the bottom but still works fine (see photo). Will not come with the nuts or any wiring. Asking for £40+ postage. Turbo elbow. In good working condition. Never fitted...

Clearing out parts for an S13 project, For sale: Driftworks Front Lower Control Arms For Nissan 200sx S13/180sx 88-97 These were bought in November last year and have barely left the box, never been installed. Selling on the drift works store for 209 quid but I'm happy to take 175 so I can...

EDIT: SOLD Bought a pair of S13 Monopro HSD coilovers in December for a project that never ended up happening due to Corona. Never been installed, picked them up out of the box and that's it, just looking to get some kind of return on them. They're 795 pounds on the shop but I just want to get...

Selling my unused set of DW 800CC Injectors, set is made for CA18DET S13, but should work in plenty of other cars too. Compatible with E85. Asking for 300€ OBO, Injectors are located in Finland, willing to ship elsewhere

Got these two freshly built T28R’s for sale. They are both built from all brand new parts since the old cores ended up being scrap. Both were balanced via TT VSR after. Part list includes - New core New upgraded (inconel) turbine wheel New ball bearing cage, pin, seals & piston rings New...

as above, i'm after a 1.5 way diff for my 14a, not wanting a two way or stock viscous, preferably in a case ready to just chuck into my car, let me know what you have, cheers Will

Hi All, I currently own a Focus ST225 but looking to get an S13 I've always loved this cars and looking to get a good base. Nothing to overly speced out. My price range is around 7000 - 7500 depending on what I get for my focus my number is 07734098444

Hi all as above looking for a clean bootlid no rust etc. Willing to travel to collect ASAP. Let me know what you got