325i

HI GUYS GOT MY BEAMER UP FOR SALE ONLY USED IT AT A FEW DRIFT DAYS GOT A NEW CLUTCH MOST OF THE INTERIOR IS STRIPED OUT DOESN'T SMOKE OR RATTLE WITH THE EXCEPTION OF ONE TAPPET THAT MAKES A LITTLE NOISE TILL WARMED UP A BIT HAS STANDARD BMW ALLOYS 2.5 ENGINE WITCH HAS DONE ABOUT 140.000 MILES...

doing the usual inlet manifold conversion to my 328i. can anyone help me out? pm or text. 07969923826 thanks, mike

Hey everyone:wave: Need some help since Kaaz wont help me with the info for installing the Kaaz 1.5 way diff into e30 casing diff. I have the 1.5 way in an e36 medium M3 casing at the moment and going to get rid of my e36 and buy an e30 318is instead (cheaper to run then the 325i) I found...

Hi! When decatting a 325i, should I cut the cats and the center boxes too? Or just the cats? If I remove the center boxes will it reduce the low down torque even more? I've got this type exhaust (I saw single center boxed ones too) Thank you!

Hi! I was looking for some anti roll bar upgrade to my 325i, without going the adjustable eibach, etc., way. On realoem I found this: 316i, 318i, 318is: stock 23,5mm in front, 15mm rear. M-tech arbs: 26mm, 18mm. 325i, 328i: stock front 24mm, rear 15mm. M-tech arbs: 25,5mm, 18mm. My...

I think I may aswell start this thread now. Got some pics ready to put up to. The "plan" is to make a 325 (M50B25) turbo drifter:thumbs:. Im not funded very well so gave myself till next summer to have everything done properly. Since my daily shell has already been crashed before I bought it...