s13

  1. R

    Wanted S13 Front and Rear Suspension

    I'm looking for some parts to use for a subframe swap on an old Datsun. I need a complete rear s13 subframe with 4 bolt hubs, brakes, handbrake cables etc. Also looking for s13 front hubs with 4 stud hubs and brakes.
  2. jb_s13

    Wanted Sr20det alternator & starter.

    As per title, I’m after a working alternator & starter motor to fit my sr20det. Can collect if near Dorset or willing to post if you’re further afield. Thanks.
  3. jb_s13

    Wanted SR20DET setup.

    Looking for a complete sr20det package to drop into my s13. Dorset area preferred but can travel for a good spec.
  4. jb_s13

    SOLD CA18DET for sale.

    looking to sell my CA18DET out of my s13 as I’ve just purchased an SR20. will be sold complete with all ancillaries, loom & ecu. Stage 1 horsham developments ecu. Main bearings, big end bearings & reground crank (20/01/18) Lightened flywheel & arp bolts. Exedy clutch, new clutch master &...
  5. jimycrimson

    Rebuild brake/clutch lines S13

    Hi! I've the next cuestion, I wanna rebuild my old lines from clutch master cylinder to slave and brake master cylinder to calipers. Is it posible with typical cooper kit from ebay? My question is about nuts fittings.
  6. Z

    Wanted S13 Coilovers

    Looking for used, good condition coilovers for S13. If you have something for sale pleas contact me! Thank you!
  7. R

    Wanted S13 wheels

    Looking for some wheels for my s13. 4x114.3 pcd. Ideally 16 inch wheels but open to anything. With or without tyres. What you got? Cheers
  8. Jay1017

    Rebuilt Garrett T25

    Here I have my rebuilt T25 for sale aka GT2554. Originally from a CA18DET. The turbo has just been rebuilt and has not been mounted or covered any miles. The turbo has had: All new seals & gaskets New bearings including an uprated 360* thrust bearing to handle higher load from high boost...
  9. Lewbags

    Wanted S13 front and rear overfenders

    Looking for front and rear over fenders for my s13. Ideally +25 front and +50 rear. Good condition only please. Based in Essex but will be travelling up to BDC this weekend if someone wanted to bring them along. Ta
  10. B

    SOLD S13 steering rods and ends with proforma rack spacers

    As title suggest a set of pretty much new steering rods and ends with Superforma Rack Spacers. Items based in Sittingbourne, Kent. £100 delivered to UK Mainland. Any questions please contact Ben on 07961732131.
  11. alextull1

    For Sale RB25 S13 – CS2’s, Geomasters, Nistune – 357hp

    RB25 S13 – CS2’s, Geomasters, Nistune – 357hp I’ve owned this ridiculous machine for the past 8 years, will probably regret selling but would like to consolidate all my cars into one fast daily. Will consider PX on anything Japanese, comfort spec (JZX, PS13, S15 etc) with cash either way...
  12. B

    For Sale Nissan 200SX S13 Destroy Or Die Drop Hubs

    This is a pair of modified front hubs done by Destroy Or Die. Look them up. Removed from my S13, give massive lock with supporting mods. Not been used, just been mocked up on car but breaking the car as circumstances have changed. I do have other modified parts for sale, check my other...
  13. B

    For Sale Nissan S13 SR20DET SR13 Takumi Rein Hard Titanium Twin Shotgun Exhaust System

    This is a Takumi Rein Hard titanium twin shot gun exhaust system removed from my S13 SR20DET. This will fit S13 models with the SR engine. May fit CA models but may need to change downpipe. The cat back system is Takumi, the downpipe and decat are unbranded. Sounds as good as it looks...
  14. B

    For Sale S13 front bumper green - Kent - £50

    Front bumper in green for Nissan S13. All in good order, will straighten up once bolted to car. Been sat in storage. Comes complete as shown. Item collection from Sittingbourne, Kent Am attending Rockingham in the 13Th September so can bring with me. £50 Ben 07961732131
  15. Danimaldrifter23

    1jz engine wanted !! Even if its blown or not

    Looking for a 1jz engine . Complete or a spairs and repairs engine. Vvti or non vvti isnt an issue . Thanks
  16. craigjj828

    project thirteen

    so this is my project car its a 1991 200sx(uk) running the ca18det i have owned the car for 4 years now its had several looks along the road but is currently sporting a miss match kit odd wheels and some throwback d1 style decals i got the car as a totally standard car but it was rotten so i...
  17. jb_s13

    Wanted 5x114 17"s or 18"s.

    After some cool wheels for my s13. 5x114, 17 or 18", 9 or 9.5J. Budget of around £500. Dorset/Wilts area or able to post.
  18. B

    SOLD Nissan 200SX S13 Non-Rolling Shell Kent £1200 with V5

    As the title suggests, selling my S13 non-rolling shell. Complete with V5. Comes complete with all panels, including body kit, and it does have a Bootlid, in reasonable nick, just welded up the spoiler holes. Only rust really is to Near Side Rear Pocket. Chassis rails all solid. Will need a...
  19. M

    For Sale S13 Bits For Sale

    Hey, I've got the following for sale as they're of no use to me anymore. Open to offers. Feel free to drop me a message on here if you have any questions. S13 rear lights with all parts. All in very good condition. Rear lights have a bit of mastic on them for some reason but they seem intact...
  20. 9

    S13 Frist car -> Rebuild

    So, i decided to share my story on the DW Forum. I bought this Nissan 200SX back in 2016 when i just got 18. I found this "unicorn" in Principality of Liechtenstein (i live just infront of that small country), an old guy drove this car many years and he sold it to me (now he drives a lowered EP3...
Back
Top