s14a

SOLD

Hello my cluster for my s14a cluster gauges don’t work I’ve checked the fuse. All the lights everything works apart from the gauges. Anyone know what could be the problem, maybe a wiring diagram for the cluster too If someone could help be much appreciated

Hi everyone. I'm looking to replace the rev counter on my 1999 s14a 200sx. I'm after either the rev counter and board on its own or a whole dash, either is fine. Tried going down the route of checking soldering etc but the board is fried, so no good. Or anywhere I can buy a new one or...

New purple SFS Performance radiator hoses for sale. £50 delivered.

Hi, Thought I would advertise it on here before facebook/ebay as more likely someone will want this for what it is. To start with this is a very BARE shell. It has absolutely NO running gear or suspension and other than the tank and body panels it needs everything else - i do have front/rear...

Looking for a Nissan Silvia s14a or Nissan skyline r33. 8k budget. What’s about?

long story short is as this- Bought an s14 with what sounded like release bearing noise (whine then clutch in and it dissapear) Bought an exedy 3 puk clutch and brand new release bearing. Fitted them, noise still the same. Contacted people selling the bearing, they said very rare for them to be...

Hi, loooking for a good condition front windscreen for an s14/14a if its loose already that's ideal if not I can come and remove if still fitted to the car. Need something soon as possibly really. Cheers

Hello I’m new to the Nissan stage. Someone has offered me a s14a for £3500. The engine is standard on 170k so soon will need a rebuild. It’s got rust on driver side sill witch needs replacing and arch (drivers side). Also the rear fenders need respraying, The doors don’t lock at all needs rods...

I have ordered lots of sheet mild steel 0.8-1.0mm thick and some U shaped runners to cover the sill jacking points (after I cut them open to see how crap the previous repairs were.) The car was hopefully going to become my daily/track toy and I don't really have a time frame in mind but I...

Rear suspension arms £20 - https://www.ebay.co.uk/itm/Nissan-s14-s14a-s15-r33-suspension-camber-toe-and-traction-arms/222872075554 Set of shocks and springs £70 - https://www.ebay.co.uk/itm/Nissan-s14-s14a-s15-R33-gtr-front-and-rear-shocks-and-springs/222872001004 Exhaust manifold £15 -...

My s14a ignition barrel is becoming unreliable, so I plan on fitting a start switch just to replace the 'start' part of the ignition as 'acc' and 'on' work fine, its just the starting part which has become dicky. I have found a similar thread and a suggestion that s13 wiring might not be...

since I bought my s14 front end hasn't gripped as much as I would have expected, add this to an incident I had in the car of which involved a kerb, I need a geometry setup. Standard arms Lowered on coilovers 18" rota gtr's Camber adjustable top mounts Anyone got a setup that holds the front...

I figured 8 years was long enough to wait before putting up a build thread. I’ll try and remember some of the stuff I’ve done to it over the years but most prob just jump into the recent stuff as that’s much more interesting. So back in 2009 when you could pick up s-bodies for pennies I went...

Am considering swapping my S14a 98' for a Jzx90 mark 2 or jzx90/100 chaser or mark 2 depending on whats about.. Flame Red 88,500 Miles Cream Leather interior in very good condition with no rips or tears. Stamped service till 55K then receipts from then on with a LOT of paperwork. MOT till...

T28 turbo off my s14a has normal amount of play for a journal bearing, boosted fine at a bar for past couple years and has stock actuator fitted - SOLD Hdev manifold, has crack around turbo flange I can repair for a bit extra but someone might want it to change the flange to something else -...

So, im looking to build an RB25 powered S14A. Its a track only car and i want to run as little wiring as possible. My question- Has anyone ever run an RB on a bare engine loom, Fuel pump wiring, ECU power & ground etc. it will be running a standalone, and any thing else i need will be working...

Got a few parts taking up space that i dont need any more.. IHI turbo, power enterprise PE1420 needs a rebuild but apparently a very good upgrade from the standard t28, Ive not used this personally due to needing a rebuild but done some research on the unit itself and they're decent - £50 2...

I am need of a working s14a speedo/rev counter, mine has broken when taken apart. Not fussed about mileage but rev counter HAS to work. Cheers

After a 5 speed manual box for an s14a sr20det as close to Oxford as possoble and as soon as possible PFA