CA18DET preservation society

You really don't need the oil cooler for the diff, most people find theirs has never ran and just rip them off and block the pipes.
 
r3k1355 said:
You really don't need the oil cooler for the diff, most people find theirs has never ran and just rip them off and block the pipes.
Click to expand...
+1 for this. When I did my S14 subframe swap I pulled all the diff cooler out. The pipes & cooler core where bone dry. I pulled the diff out of a mates S14 & the pipes actually had dust in them.
 
There's lots of different sizes so you'd have to be more specific.

None that will fit on the standard manifold tho.
 
r3k1355 said:
There's lots of different sizes so you'd have to be more specific.

None that will fit on the standard manifold tho.
Click to expand...

I will borrow if off him and take some measurements, i have an aftermarket manifold with a t3 flange so it will bolt on
 
Have you considered lifting your foot a touch? And they dont sound e.p.i.c, they sound noisy and piss of track owners.
 
adam-dorward said:
Are they hard to fix and set up?
Click to expand...

Not at all just a couple of wires that you have to join with the ECU, say what 20 mins? Just have the pin diagram to hand. Was thinking of getting one for my current but no use really. Besides joining to the ECU wiring there's nothing else to do to install it just play with the settings for desired effects.
 
THICK SOUP said:
+1 for this. When I did my S14 subframe swap I pulled all the diff cooler out. The pipes & cooler core where bone dry. I pulled the diff out of a mates S14 & the pipes actually had dust in them.
Click to expand...

some people have installed a LED light between the power supply and the pump. the LED light turns on as soon as the pump gets power.
 
Heres what my CA looked like on Saturday morning



Heres what it looked like sunday morning



This is no 4, no3 wasn't as bad & 1&2 where fine and showed no signs on det.
 
Any updates lez Bruce lee?

Big changes comeing to my ca.
Got a new Wardy manifold, suggest you all check his work out, around £450 gets you a very very tidy fully back purged, steam pipe manifold, no more crackS!
I can get you his details or number if your interested it's easily full race quality.
-getting a td05-18g
-Tomei pon cams
-sard 600cc injectors.
Will be getting mapped by Greg @ pro tuner
 
dori_wey said:
Any updates lez Bruce lee?

Big changes comeing to my ca.
Got a new Wardy manifold, suggest you all check his work out, around £450 gets you a very very tidy fully back purged, steam pipe manifold, no more crackS!
I can get you his details or number if your interested it's easily full race quality.
-getting a td05-18g
-Tomei pon cams
-sard 600cc injectors.
Will be getting mapped by Greg @ pro tuner
Click to expand...


No not yet mate, ive not really looked too deep into it yet just shut up the workshop n left it sat there. A few people have suggested it could be different things. Not sure what im gonna do engine wise either stick at the ca's or go a different route.
 
You must log in or register to reply here.
Back
Top